布电线及电源线

型号:

用途:本产品适用于交流额定电压450/750V及以下动力,日用电器、仪器、仪表及控制用铜芯聚氯乙烯绝缘电线(电缆)。

关键词:

布电线及电源线

所属分类:

产品描述

  布电线及电缆

  Electrical wires and cables for interior wiring

  执行标准

  STANDARD IMPLEMENTED

  执行标准:GB5023-1997

  Executive standard:GB5023-1997

  使用特性

  APPLICATION PROPERTIES

  电缆的长期允许工作温度;BV-90、RV-90应不超过90℃,其它型号不超过70℃固定敷设用电缆(电线)的敷设温度不低于0°℃。

  允许弯曲半径;电缆外径(D)小于25mm者应不小于4D,电缆外径(D)25mm及以上者应不小于6D。

  Long term service temperature:BV-90 and RV-90 not exceeding90℃,other models not over 70℃;permanently laidcables not lower than o℃.

  Bending radius allowed:for cables with outer diameters(D)lowerthan 25mm:not less than 4D;if the outer diameter is 25mm ormore,the bending radius shall not be less than 6D.

  产品用途

  USAGE

  用途:本产品适用于交流额定电压450/750V及以下动力,日用电器、仪器、仪表及控制用铜芯聚氯乙烯绝缘电线(电缆)。

  Usage:This product is fit for power supply with rated AC voltage up to450/750V,or serves as copper core PVC insulated electric wiresfor daily electrical appliances,instruments and meters and control equipment.

111

  技术性能及参数

  Technical performances and parameters

  1)导体均按GB/T3956-1997《电缆的导体》标准规定要求。

  2)绝缘用聚氯乙烯材料要求,耐温90℃电线电缆应采用PVC/E型聚氯乙烯混合物材料,其余耐温70℃的均用PVC/C型聚氯乙烯混合物材料挤包绝缘层。

  3)内护层采用非硫化型橡皮或塑料混合物挤包;护套层采用PvC/ST4型聚氯乙烯混物材料挤包。

  4)产品性能要求及试验方法,按本标准(GB5023.1、2、3)规定,进行检测,全部通过则为合格品。

  5)电缆(线)直流电阻及绝缘电阻(见表2)。

  1)Allconductors follow the _requirements specified inGB/T3956-1997"cable conductors".

  2)PVC for insulation:PVC/E for 90℃ wires and cables;PVC/C forthe rest with the temperature at 70℃.

  3)Inner protecting layer adopts non-sulphurised rubber or plasticcomposite;sheath layer adopts PVC/ST4.

  4)Product performances and test methods follow GB5023.1、2、3.

  5)Refer to table 2 for DC resistance and insulating resistance ofthe cables.

111

 

  交货长度

  Length of deliver

  一般成卷或成盘交货。交货总长度中可配给的短段比例,按双方合同协议商订。

  Usually delivered in rool of reel.In the full length of delivery,aproportion of short cables are allowed,subject to contract andnegotiation.

欢迎您的留言咨询

我们的工作人员将会在24小时之内(工作日)联系您,如果需要其他服务,欢迎拨打服务热线:0514-84239996